[time-nuts] OT stuffing boards: was GPS interface/prototyping board
albertson.chris at gmail.com
Fri Jun 24 22:24:28 EDT 2016
On Fri, Jun 24, 2016 at 9:52 AM, Don Latham <djl at montana.com> wrote:
> I do not see why a small pick and place assist system could not be built on a 3-d printer.
You are not the first to think of this. But the problem is
1) moving the reels of parts,
2) programming the machine. Translating the PCB design files into g-code.
3) Building a vision system. With very small parts you really can't
run open loop
Redondo Beach, California
More information about the time-nuts