[time-nuts] Lucent RFTG-u REF0-REF1 cable
Jerry Hancock
jerry at hanler.com
Tue Nov 14 23:29:06 EST 2017
I can’t find the instructions on how to make the REF1 work without the REF0. Other than adding the 10Mhz, do I have to do anything to it to enable it to run without the REF0?
> On Nov 14, 2017, at 7:52 PM, Tim Shoppa <tshoppa at gmail.com> wrote:
>
> Isn’t info about what satellites are where, just eye candy and irrelevant to a real GPSDO?
>
> Tweaks to the elevation mask ought to be measurable in the PPS quality (if they aren’t then they’re irrelevant).
>
> Tim
>
>> On Nov 14, 2017, at 10:39 PM, Mark Sims <holrum at hotmail.com> wrote:
>>
>> The M12 uses different commands for sending a lot of the data since it is tracking more sats and the old commands were limited to 6 or 8 sats. I doubt it would work the the RFTG. There might also be a 3V vs 5V problem.
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
More information about the time-nuts
mailing list