[time-nuts] nuts about position

[Bob kb8tq]

Hi

You mean that LH does not translate the data to the correct format *and* submit it for post processing ????? 

There *is* a lot of data when you turn all this stuff on. If you can get above 115K baud, it’s well worth it. 

=====

One important qualifier to re-state. L1 post processing is very dependent on the distance to an “open” source
of correction data. The spacing of those sites over the US is highly variable. If you get outside the US it is very 
much a “that depends” sort of thing. Some countries apparently don’t have the same sort of open site network 
that we have in the US. 

Bob

> On Apr 30, 2018, at 4:36 PM, Mark Sims <holrum at hotmail.com> wrote:
> 
> Coincidentally, yesterday I tweaked up Lady Heather's Ublox code to enable all of the necessary raw data messages.  Heather also enables the raw messages from Trimble TSIP speaking receivers,  the NVS CSM24 receiver, and the Furuno GT87 receiver (if baud rate is >=115200).
> 
> Heather can write a raw data capture file (/dr=filename on the command line or WY from the keyboard).  You should be able to convert those raw capture files to RINEX and then post-process those.
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.