[time-nuts] Need Oncore connector info.

Majdi S. Abbas msa at latt.net
Tue Feb 27 12:13:02 EST 2018


On Tue, Feb 27, 2018 at 08:01:12AM -0600, John Green wrote:
> I need the part number of the connector that the Motorola Oncore series GPS
> receiver plugs into.  Does anyone have that info at hand?

	Which Oncore?  The M12+ and the earlier ones are different.
Early receivers used a standard dual row 0.1" (2.54mm) pitch for 
power and data, and an MCX antenna connector.  

	Later receivers used a 1.27mm pitch (0.050") 2x5pin header
with (from memory) the same pinout.

	You should be able to search on pitch, row and pin count on
your distributors website and find a variety of manufacturers.  
There's nothing special about these connectors.

	And while you're ordering them, Trimble went to a 2x4 pin
2mm / 0.079" connector.  If you're going to play with a Resolution T
SMT module or something along those lines down the road, you might
as well order that up, too.

	--msa


More information about the time-nuts mailing list