[volt-nuts] volt-nuts Digest, Vol 33, Issue 6

Bob Smither smither at c-c-i.com
Fri May 11 00:41:17 UTC 2012

On 05/09/2012 10:41 AM, Demian Martin wrote:
> AC Volt-nuttery has its limits and challenges. I now have 3 Fluke 540B's,
> 6-8 Thermal converters, an assortment of AC meters culminating in a Fluke
> 8506A as well as an Optimation AC calibrator, a Tek 191 scope calibrator and
> other AC sources for calibration.

An Optimation CS-110 by any chance?  I picked one up on EBay - seems very well
made.  I can't say I have found a lot of use for it, but it is handy for
checking the AC (and DC) ammeter functions on some of my meters.

Any chance you have a source for the non-standard 3 prong power connector on the
back?  My unit has a male 3 prong connector recessed into the back panel.  Two
prongs are ~ .615" center to center.  The third pin is centered between them
horizontally and offset vertically by ~ .08" (difficult to measure).  Each prong
is ~ .122" in diameter.

Best regards,
Bob Smither, PhD                                   Circuit Concepts, Inc.
                An armed society is a polite society.
                  -- Robert Heinlein
Smither at C-C-I.Com  http://www.C-C-I.Com  281-331-2744(office)  -4616(fax)
-------------- next part --------------
A non-text attachment was scrubbed...
Name: smither.vcf
Type: text/x-vcard
Size: 140 bytes
Desc: not available
URL: <http://www.febo.com/pipermail/volt-nuts/attachments/20120510/8209f353/attachment.vcf>

More information about the volt-nuts mailing list