[volt-nuts] Resistors for LTZ1000A circuit

Andreas Jahn Andreas_-_Jahn at t-online.de
Tue Dec 10 15:25:06 EST 2013

Hello Randy,

another source could be the UPW50 or UPW25 series of wire wound resistors.
Some values are available at RS-Components.
the 70K = 50K + 20K
the 12,5K = 10K + 2K + 500R (50 degrees setpoint temperature)

another possibility is the trimming service of DigiKey for VSMP resistors.
You can get every value within 4 ohms - 120K.
the only disadvantage is that there is only little mechanical decoupling 
against PCB stress of SMD devices.

With best regards


Am 10.12.2013 04:01, schrieb Randy Evans:
> Does anyone know a good, hopefully low cost, source for the precision resistors required for the LTZ1000A circuit as shown in the LTZ1000A data sheet.  I found the 1K and 120 ohm .01% resistors on Mouser but no source found for the 13K and 70K .01% resistors.  Vishay is quite expensive but i haven't contacted them directly.
> Thanks,
> Randy Evans
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.

More information about the volt-nuts mailing list