[volt-nuts] Fluke 732A themistor reading

[Randy Evans]

Can anyone tell me what value to expect for a Fluke 732A thermistor
reading?  I am looking to get a used 732A and one of the things I was told
to look for is to measure the thermistor reading after the unit has heated
up for at least an hour.  I saw in one of the posts that a "typical"
reading was 4950 ohms.  One vendor I asked said he measured about 3600 ohms
after a two hour warmup. I was concerned that this is too low.  What do you
guys think?

Thanks,

Randy