[volt-nuts] Precision resistor testing

Mitch Van Ochten mitch at vincentelectronics.com
Fri Nov 14 20:21:18 EST 2014


Hi Dick,

I have a small temperature chamber and can create plots characterizing the resistor like the one attached.


Best regards,

mitch

-----Original Message-----
From: volt-nuts [mailto:volt-nuts-bounces at febo.com] On Behalf Of Richard Moore
Sent: Friday, November 14, 2014 5:36 PM
To: volt-nuts at febo.com
Subject: [volt-nuts] Precision resistor testing

I’ve built a little box with two 10kohm precision resistor assemblies, using Fluke resistors — one ass’y is two 20k managing wire on shellacked mica cards in parallel, and the other is made of eight 5k wire wounds in sealed green plastic cases in series/parallel. These are not exactly 10k ohms each, but are about 30ppm (high) for the mica card, and 20ppm (low) for the green plastics, according to my HP 3458A. 

I would like to get them accurately characterized, but never having done this, I don’t know who to have do it or how much it would cost. Any ideas or suggestions? They can be shipped anywhere cheaply as the box is small, light, and very durable.

TIA
_______________________________________________
volt-nuts mailing list -- volt-nuts at febo.com To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
-------------- next part --------------
A non-text attachment was scrubbed...
Name: Rubicon 80459.pdf
Type: application/pdf
Size: 37052 bytes
Desc: not available
URL: <http://www.febo.com/pipermail/volt-nuts/attachments/20141114/ccf23ba1/attachment-0001.pdf>


More information about the volt-nuts mailing list