[volt-nuts] Fluke 760A Calibrator offered FOC
GandalfG8 at aol.com
GandalfG8 at aol.com
Fri Aug 7 02:06:45 EDT 2015
Hi Pete
Thanks for your comment, I have considered stripping it for parts and
might still do so if there's no takers, but it's in such nice condition that
I've been very reluctant to do that, which is probably one of the main
reasons I'm crowded out by old test gear and radio kit that I'll never find time
to use again:-)
Regards
Nigel
GM8PZR
In a message dated 07/08/2015 05:17:45 GMT Daylight Time,
pete at petelancashire.com writes:
A great source of parts for DIY volt-nut projects
On Thu, Aug 6, 2015 at 3:43 PM, Nigel Clarke via volt-nuts <
volt-nuts at febo.com> wrote:
> I have a Fluke 760A calibrator, complete with original manual including
> schematics etc, that I haven't powered up for a few years but as best I
> remember was working last time I tried it.
>
> This is available free of charge to anyone willing and able to collect
from
> the west coast of Scotland.
>
> It's far too heavy to ship and should be accepted as is, I won't be
testing
> it again as I don't have time to get distracted chasing any problems
that
> might arise.
>
> Regards
>
> Nigel
> GM8PZR
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.
>
_______________________________________________
volt-nuts mailing list -- volt-nuts at febo.com
To unsubscribe, go to
https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
and follow the instructions there.
More information about the volt-nuts
mailing list