[volt-nuts] PCB Artist

Herbert Poetzl herbert at 13thfloor.at
Tue Dec 13 08:22:56 EST 2016

On Mon, Dec 12, 2016 at 04:39:36PM -0800, Randy Evans wrote:
> Does anyone have experience with PCBArtist?  

Sorry, no PCBArtist experience here.

> It looks pretty good for 2-layer board up to 60 
> in^2 for $33 but I have no experience with it.  

> I was looking at Eagle PCB but it's pretty expensive 
> for a 4-layer capability version.

A litte apples and oranges here :)

The Eagle Light version can be used for free for
non-profit purposes and works for up to 4x3.2inch 
with two layers.

If you don't have any personal preference, then
KiCad is definitely the way to go. It has improved
dramatically since it got the CERN treatment and
doesn't cost a cent regardless of size and layers.


> Thanks,

> Randy Evans AE6YG
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.

More information about the volt-nuts mailing list