[time-nuts] SSR-6t Connector

dlewis6767 dlewis6767 at austin.rr.com
Thu Dec 20 15:48:08 UTC 2012


The SSR-6t is a 3.3v device.






--------------------------------------------------
From: "paul swed" <paulswedb at gmail.com>
Sent: Thursday, December 20, 2012 9:41 AM
To: "Discussion of precise time and frequency measurement" 
<time-nuts at febo.com>
Subject: Re: [time-nuts] SSR-6t Connector

> Not to hijack the thread. I purchased a ssr and have not rcvd it yet. But
> my simple interest is to if needed replace the rcvr in my z3801. There 
> have
> been threads on time-nuts that these rcvrs do fail with age.
> My belief is that though the connector on the 3801 may be different and it
> is 5V, essentially connecting the 1 pps TX RX data and power should allow
> this to replace the older rcvr.
> Am I on the right track?
> As a longer term goal and question does this new rcvr actually improve a
> 3801s stability?
> Thanks
> Paul
> WB8TSL
>
> On Thu, Dec 20, 2012 at 10:16 AM, David Martin <
> drmartin at ivietechnologies.com> wrote:
>
>> I had a Motorola M12+ all hooked up with a RF pigtail and data header so 
>> I
>> just unplugged the Motorola and plugged in the SSR-6t.
>>
>> The data connector was purchased from digikey several years ago and the
>> details have been lost in the dust.
>>
>> However it looks like
>>
>> http://search.digikey.com/scripts/DkSearch/dksus.dll?Detail&name=A33546-ND
>>
>> I'm unhappy with the one I'm using as the contacts spring pressure is 
>> weak
>> against the connector pin -- I will have to consider looking for a more
>> "firm" fitting data connector.
>>
>> The RF pigtail was also obtained years ago from data-alliance.net - their
>> P3B adapter cable.
>>
>> See
>>
>> http://www.data-alliance.net/servlet/-strse-800/MCX-BNC-female-Adapter/Detail
>>
>> - Sent from my iPhone -
>> Please Reply To
>> David Martin
>> drmartin at ivietechnologies.com
>> 801-372-0978
>>
>> Just curious,
>> what connector/pigtail/adapter board did you use to access the 2x5 1.27mm
>> pitch connector on your SSR-6T.
>> Thanks,
>> Dale NV8U
>> _______________________________________________
>> time-nuts mailing list -- time-nuts at febo.com
>> To unsubscribe, go to
>> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
>> and follow the instructions there.
>>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to 
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there. 




More information about the time-nuts mailing list