[time-nuts] EZGPIB Question

paul swed paulswedb at gmail.com
Wed Nov 20 15:21:08 EST 2013


Thanks everyone. I have some digging to do I see. Would love to use it on a
more modern system.
Regards
Paul.


On Wed, Nov 20, 2013 at 1:53 PM, John Miles <john at miles.io> wrote:

> > -----Original Message-----
> > From: time-nuts-bounces at febo.com [mailto:time-nuts-
> > bounces at febo.com] On Behalf Of Lizeth Norman
> > Sent: Wednesday, November 20, 2013 8:43 AM
> > To: Discussion of precise time and frequency measurement
> > Subject: Re: [time-nuts] EZGPIB Question
> >
> > The programming of the ENET/100 has to be done with an older ver of
> > Labview
> > (7.1 IIRC), something that has no later than win 2k as an operating
> system.
> > I had one of these and went through the setup of the ip address. Once it
> > worked, it was like a hardware controller. (using LV 8.0)
>
> No personal experience, but apparently it can be done with a third-party
> utility as well.  Search http://www.ke5fx.com/gpib/faq.htm for the term
> "GPIB-ENET" and  you'll (eventually) find W2HX's instructions.
>
> -- john, KE5FX
> Miles Design LLC
>
>
> _______________________________________________
> time-nuts mailing list -- time-nuts at febo.com
> To unsubscribe, go to
> https://www.febo.com/cgi-bin/mailman/listinfo/time-nuts
> and follow the instructions there.
>


More information about the time-nuts mailing list