[volt-nuts] Now Pace desoldering maintanance question
jfor at quikus.com
Mon May 21 22:00:48 UTC 2012
I noticed you have the Millipore disposable filter in the suction line.
That catches most all the flux particles and keeps the pump pretty clean
> Thanks, i tried it, made a return hose on it but it splattered all around
> so the rag over the output was a better idea. Let it suck some nafta (had
> no ipa anymore) and waited a few minutes, then pumped it empty but the
> nafta was as clear as it went in so I guess my pump is clean.
> Thanks. All works well again.
> Fred PA4TIM
> Op 21 mei 2012 om 18:07 heeft Mark Sims <holrum at hotmail.com> het volgende
>> The exhaust port is just above the suction port on the front panel. It
>> has the pressure adjustment knob. I use pure isopropyl alcohol. Be
>> careful... flammable solvents and DC motors with sparking brushes are
>> not friends.
>> volt-nuts mailing list -- volt-nuts at febo.com
>> To unsubscribe, go to
>> and follow the instructions there.
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to
> and follow the instructions there.
More information about the volt-nuts