[volt-nuts] Matched resistors

[Tom Knox]

Hi Randy;
I would look at Visha Foil resistors
http://www.vishaypg.com/docs/63120/hzseries.pdf
Hope that helps.
Cheers;
Thomas Knox



> Date: Wed, 16 Jul 2014 17:44:10 -0700
> From: randyevans2688 at gmail.com
> To: volt-nuts at febo.com
> Subject: [volt-nuts] Matched resistors
> 
> I am building a 10V voltage reference based on the LTZ1000 and the design
> is essentially done but I am looking for a pair of matched resistors that
> track very closely over temperature.  The absolute value of the pair is not
> important, anything between 50K and 200K ohms would be ideal, but the
> matching ratio is very important.
> 
>  I looked at the 100K ohm LT5400 quad resistor array from Linear Technology
> but it has a worst case long term accelerated shelf life spec of 10 ppm (at
> 150C) matching ratio and long term matching ratio drift of <4ppm (at 70C).
>  I would like something much tighter if possible since that would mean I
> likely don't need an oven for a couple of ppm worst case accuracy over time
> and temperature.  I can make the LT5400 work but I would need to do
> temperature characterization and circuit compensation.  Doable but
> undesirable.
> 
> Does anyone have any ideas for a good ratio matched resistor pair,
> hopefully not too expensive?
> 
> Thanks,
> 
> Randy Evans
> _______________________________________________
> volt-nuts mailing list -- volt-nuts at febo.com
> To unsubscribe, go to https://www.febo.com/cgi-bin/mailman/listinfo/volt-nuts
> and follow the instructions there.